Little Dal+ on Obitsu Body 11

From DollyWiki

Materials

• Little Dal+
• Obitsu Body 11
• Philips screwdriver (not pictured)

Tutorial

Remove the stock body

Unscrew the screw from back of the head. Remove the head's back plate.

Unscrew the two screws from the neck peg holder. The neck peg holder will no longer be needed. Store it where you can find it in case you want to use it in the future.

Prepare the Obitsu body

Remove the arms, and gently pry open the front and back panels of the upper part of the torso.

Slip the washer onto the neck peg from the bottom.

You may wish to unscrew the Obitsu neck peg, replace it with the medium peg, and screw it back together.

Note: The washer can instead be placed just below the removable top of the neck peg, which must be done while the neck peg is unscrewed. This method will leave a gap between the Little Dal+'s head and the top of the neck, which may be undesirable.

Return the neck piece to the body.

Reassemble the body by gently snapping the front and back body plates together.

Attach the head and body

Place the Obitsu body's neck against the Little Dal+'s front head plate.

Screw the neck peg-holding screws back into place. Keep the washer below the screws, and do not use the original neck peg holder. The screws are necessary to hold the washer in place.

Screw the back head plate back onto the front head plate.

Completion

The Little Dal+ on Obitsu 11cm body is complete.